RME Audio Advanced Remote Control Uživatelská příručka stáhnout pdf (Strana 61)

User's Guide Fireface UCX © RME

25.4 Section Control Room

In the section Control Room the menu Assign is used to define the Main Out which is used for

listening in the studio. For this output the functions Dim, Recall, Mono, Talkback, External In

and Mute FX are automatically applied. On the unit the VOLUME knob also follows this assign-

ment.

Additionally the channel will be shifted from the Hardware

Outputs into the Control Room section, and renamed Main.

The same happens when assigning Main Out B or the

Phones. The original name can be displayed by the function

Names in the View Options – Show at any time.

Phones 1 to 4 will have Dim (set in Settings) and a special

routing applied when Talkback is activated. Also putting them

beside the Main Out increases the overview within the output

section greatly.

Note

: Phones 1 to 4 can be freely assigned in TotalMix FX. As

the Phones output on the unit is hardwired to channels 7/8,

selecting PH at the unit will always change the output level of

channels 7/8, no matter which channels have been selected

for Phones in TotalMix FX.

Dim. The volume will be reduced by the amount set in the

Settings dialog (F3).

Recall. Sets the gain value defined in the Settings dialog.

Speaker B. Switches playback from Main Out to Main Out B. The faders of the channels Main

and Speaker B can be ganged via Link.

Mono. Mixes left and right channel. Useful to check for mono compatibility and phase problems.

Talkback. A click on this button will dim all signals on the Phones outputs by an amount set up

in the Preferences dialog. At the same time the control room's microphone signal (source de-

fined in Preferences) is sent to the Phones. The microphone level is adjusted with the channel's

input fader.

External Input. Switches Main monitoring from the mix bus to the stereo input defined in the

Settings dialog (F3). The relative volume of the stereo signal is adjusted there as well.

Mute FX. Mutes Reverb and Echo on the

Main Out, to hear the mix without those

effects.

Assign. Allows to define the Main Out, Main

Out B (Speaker B), and up to four Phones

outs. The choice is limited to ADAT 1/2, as at

192 kHz the other ADAT channels are not

available anymore.

The output for the Cue signal, which is

usually Main, can also be set to one of the

Phones outputs. This setting also controls

the PFL monitoring.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 111 112

Komentáře k této Příručce

Žádné komentáře

RME Audio Advanced Remote Control Uživatelská příručka Strana 61

Komentáře k této Příručce

Související produkty a manuály pro Dálková ovládání RME Audio Advanced Remote Control